Cleaning And Storage; Storing The Product; Disposing Of The Product - Chicco Auto-Fix FAST Mode D'emploi

Masquer les pouces Voir aussi pour Auto-Fix FAST:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
To remove the child seat from the stroller:
1. Bring the carry handle into a vertical
position (B).
2. Pull the rear release handle.
3. Remove and place the child seat on a fl at,
stable surface.
WARNING: The child seat can be fastened
and unfastened with the baby inside; these
procedures could prove to be more diffi cult
due to the weight of the baby. Be very care-
ful when performing the above-indicated
procedures.

3.5 CLEANING AND STORAGE

HOW TO CLEAN THE FABRIC COVER
The child seat's fabric cover can be removed
and cleaned by hand or in a washing ma-
chine at 30°C.
To wash it, undo the harness straps, un-
thread the two straps and buckle through
the relative slots and then remove the fabric
cover (Diag. 30).
Please refer to the cleaning instructions
on the fabric label, which illustrates the
following washing symbols:
Machine washable at 30°
Do not bleach
Do not spin dry
Do not iron
Do not dry clean
Never use abrasive detergents or solvents.
Do not spin dry the fabric cover; let it dry
without wringing it.
HOW TO CLEAN THE PLASTIC OR
METAL PARTS
Clean the plastic and coated metal parts
with a damp cloth only. Never use abrasive
detergents or solvents.
The movable parts of the child car seat must
not be lubricated.
CHECKING THE CONDITION OF THE
COMPONENTS
It is recommended to regularly check the
condition of the following components
to ensure that they are not damaged or
worn out:
• Fabric cover: check that the padding does
not come out from the seams. Check the
condition of the seams: they must always
be intact and undamaged.
• Harness straps: check that the fabric weft
is not frayed or the harness strap worn out
in the parts corresponding to the adjust-
ment strap, crotch, shoulders and harness
adjustment plate.
• Plastic parts: check that the plastic parts
are not worn out, damaged or faded.
WARNING! If the child car seat is deformed
or worn out, it must be replaced: it may
no longer comply with the original safety
standards.

STORING THE PRODUCT

When it is not fi tted into the car, it is rec-
ommended to store the child car seat in a
dry place, away from sources of heat and
to protect it from dust, humidity and direct
sunlight.

DISPOSING OF THE PRODUCT

When the child car seat no longer complies
with the original safety standards, stop using
it and dispose of it at an appropriate collec-
tion point. Dispose of the product as laid
down in the environmental regulations in
force in the country of use.
19

Publicité

Table des Matières
loading

Table des Matières