Technical Specifications - IVT PS-300 Notice D'utilisation

MAINTENANCE AND REPAIR
Your Power Station PS-300 is a high-quality device which operates trouble-free for many years if handled with care and
maintained properly. Should failures occur, however, please do not try to open the device to repair it yourself. Even in
switched-off condition there may be hazardous voltages in the interior of the device. The device may also be damaged by
improper handling. Please contact an authorised expert or our service instead.
CLEANING
• Never immerse the device into water!
• Disconnect the device from both the charger and the charging adapter as well as from any consumers before cleaning.
• Clean the outside of the Power Station PS-300 only with a soft, dry cloth or with a soft brush.
Important! Never use aggressive detergents or chemical products, as this might damage the housing
surface.

TECHNICAL SPECIFICATIONS

General
Battery type:
Battery charger:
Charging adapter:
Fuse for charging adapter:
Cable length for 12 V charging adapter:
Dimensions:
Weight:
12 V DC output
Max. output current:
Max. time of operation at 10 A:
Idle current:
Deep discharge protection:
Fuse:
230 V AC output
Output voltage:
Continuous output rating:
Duration of output current:
Max. time of operation at 300 VA:
Idle input power:
Deep discharge protection:
Overload cut-off device:
ENVIRONMENTAL PROTECTION NOTE
At the end of its useful life, this product must not be disposed of together with normal household
waste, but has to be dropped off at a collection centre for the recycling of electrical and electronic
devices. This is indicated by the symbol on the product, on the instruction manual or on the
packaging. The materials of which this product is made are recyclable pursuant to their labeling.
With the reuse, the recycling of the materials or other forms of scrap usage you are making an
important contribution to the protection of the environment. Please ask your local administration
office for the appropriate disposal center.
Technical are specifications subject to change. We assume no liability for typographical errors. V4_10/2020
IVT Innovative Versorgungstechnik GmbH, Dienhof 14, D-92242 Hirschau
Tel: 09622-719910; Fax: 09622-7199120; info@ivt-hirschau.de;
12 V 20 Ah AGM (lead acid-VRLA)
Input: 100 - 240 V AC
Output: 14.4 V DC/max. 2 A
12 V DC, 12 – 14.4 V DC max. 5 A
F5A; 6.3 x 32 mm
150 cm
240 x 145 x 215 mm
10.4 kg
10 A
85 min. (with full battery)
4 mA
yes
T10A (accessible from outside)
225 V AC (+5/-8 %) 50 Hz
max. 300 VA (cos ϕ > 0.8)
1.4 A
eff
30 min. (with full battery)
3.6 VA
yes
yes
11
www.ivt-hirschau.de