Preparing The Stove; Assembling And Installing The Legs; The Smoke Outlet - Dovre 250 Installation Et Mode D'emploi

3.2.

Preparing the stove

Please inspect the stove for damage caused during transport immediately after deliv-
ery and notify your distributor in case there are any defects. Do not put the stove
into operation in the meantime.
In order to avoid damaging the stove during installation and to make handling of the
stove easier, it is recommended to remove previously all loose parts (fire-resistant
bricks, grille, ashtray, ...) from the stove. Note the location of those parts while re-
moving them, so that you have no difficulties in re -assembling the parts later on.
The stove will be supplied with the following parts:
•
A set of legs
•
A connection collar with fastening brackets
•
A "cold hand" to remove the ashtray
•
A small shovel to remove ashes
3.2.1. Assembling and installing the legs (see sketch)
Assemble both parts of the legs at the requested length
using the M6 bolts and rings. Tilt the stove backwards
and mount the legs on the pre -installed M8 bolts on the
bottom plate of the stove.

3.2.2. The smoke outlet

The stove can be connected to the chimney at the rear or at the top.
Depending on the position chosen, one opening can be covered with the blanking
plate supplied, the other one can be equipped with the connection collar supplied.
Use the fixings supplied and be sure to tightly seal the connection collar ande the
blanking plate to the stove by means of the kit or paste supplied.
25O
25
03.27934.000