Maintenance - Dovre 250 Installation Et Mode D'emploi

Masquer les pouces Voir aussi pour 250:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.

Maintenance

It takes only little effort to keep your stove in good condition.
Regularly check whether the sealing cord still closes the doors tightly enough.
The painted or enamelled cast iron mantle can be cleaned with a moist, soft cloth,
when it is almost cold.
Minor paint damage can be touched up with a can of spray paint. Your dealer can
supply you with the correct spray product. For enamel damage, small repair kits of
appropriate colour are available with your dealer.
During the first use after repainting your unit might give off some slight odour.
However, this will disappear quickly.
The glass can be cleaned with a number of glass cleaning products available on the
market. Your installer can also supply you with appropriate products. However,
never use abrasive or corrosive cleaning products.
A tight upper air slide can be adjusted with the two
screws just above the air intake holes on the front plate
(see sketch).
At the end of the heating season, seal off the chimney
with a ball of paper. You can then thoroughly clean the
stove on the inside.
If necessary, replace the sealing ropes and use fire cement to fill up possible leaks.
Remove the fire plate for better and more thorough cleaning.
You should have your chimney swept by an expert before the heating season begins.
It is useful to check the chimney for soot during the heating season as well. Check-
ing and maintaining the chimney is a statutory requirement.
When all of the above advice is heeded, you will be able to fully e njoy your stove.
30
25O
03.27934.000

Publicité

Table des Matières
loading

Table des Matières