Preparing The Stove; The Fume Outlet - Dovre 450 Mode D'emploi

3.2.

Preparing the stove

Please inspect the stove for damage caused during transport immediately after deliv-
ery and notify your distributor in case there are any defects. Do not put the stove
into operation in the meantime.
In order to prevent any damage while installing the stove and to facilitate the instal-
lation, it may be useful to first remove all or some of the loose parts from the stove
(the refractory stones, the grille, ash pan, and so on). Keep in mind how the diffe r-
ent parts are positioned as you remove them so that you can put them back in the
stove in the right way after the installation.
The following accessories are delivered together with the stove:
A set of (adjustable) legs
•
A tool for making the connection opening to the chimney (425GM – 555GM)
•
A connection collar with fastening brackets
•
A "cold handle" to open the door (450 – 555GM)
•
A "cold hand" to remove the ash pan
•
A small shovel to remove ashes
•
A loose ash lip (450)
•
3.2.1. Assembling and installing the legs and the ash lip
(425GM – 555GM) Mount the upper and lower part of the
legs to each other at the desired height, using the supplied
bolts and washers.
Turn the stove over onto its backside and then mount the
four legs to the stove. Use the washers and nuts that are al-
ready mounted to the base plate.
(450) Mount the ash plate to the front side underneath the
base plate. Screw both spindles (M8x20) into the base plate
and attach the ash plate, using two nuts (M8) and two wash-
ers.

3.2.2. The fume outlet

The stove can be connected to the chimney at the rear or at
the top.
425GM – 555GM
Select the type of connection that you want and break out
the equivalent precarved opening, using the appropriate tool.
Follow the instructions in the additional manual to make
these openings.
For top connection, break out the opening in the top plate.
For rear connection, first unhook the heat shield at the back
and break out the precarved plate. Then break out the open-
ing in the cast iron back plate of the stove.
Attach the connection collar, which is supplied with the
stove, to the fume outlet, using the two fastening brackets
on the inside and the nuts on the outside (see sketch). Be
450-425GM -555GM
25
03.27991.000