Assembling The "Cold Handle" (450-555Gm); Finishing; Packaging Materials - Dovre 450 Mode D'emploi

sure that the brackets correctly fit into their inserts at the left
and right hand side of the opening.
Put the heat shield back before connecting the stove to the
chimney.
A pre-made opening can always be closed again using a lid
which is fixed by means of a steel strip and a bolt (see
sketch). Such lid is available as spare part.
450
Mount the supplied connection collar
and lid (loose in the top plate at deliv -
ery), using the supplied nuts and the
small clamp plate (see pictures) a c -
cording to the required connecting
direction. In case of a connection at
the back, unhook the heat shield and
break away the pre-cut plate. Make
sure you close the connection collar
and the lid on the appliance tightly,
using the supplied kit or paste.
Remount the removed heat shield, if any, before connecting the equipment to the
chimney.
3.2.3. Assembling the "cold handle" (550CB)
Assemble the different parts of the
handle, i.e. a screw M8x50, a
wooden handle, a hook and a nut, as
indicated on the sketch.
This handle can be hooked on a han-
dle holder which can be mounted on
the base plate of the stove, near the
left front leg (see sketch).
3.3.

Finishing

When the stove is placed where you want it and hermetically connected to the chim -
ney, you can put all the loose parts back.
Your stove is now ready for use.
A tt e n t i on : n e v e r li gh t a f i r e w i t h t h e i nn e r p l a t e s or r e fr a c t ory s t on e s r e mov e d .
3.4.

Packaging materials

Packaging materials should be disposed of in a responsible way and in accordance
with governmental regulations.
450-425GM -555GM
26
03.27991.000