Publicité
Les langues disponibles
Les langues disponibles
Instruction for use
Switch the machine on and put it carefully on the surface you want to work
on. Hold the machine with both hands and move it in a linear or rotary way.
!
Attention!
Do not touch rotating parts!
Plaster milling:
Always make sure you observe the plaster manufacturer's product
information and notes on use.
If the notes on use and the dwell times of the plasters are observed,
optimum results can be achieved.
Attention!
!
Don`t plunge the work disc into water!
Care and Maintenance
Before the beginning of the maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel.
After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance. However, the following points have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Environmental Protection
Raw Material Recycling instead of Waste Disposal
In order to avoid damages on transportation, the tool has to be delivered in
solid packaging. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
16
Publicité
