EIBENSTOCK EPG 400 Notice Originale page 12

Degree of protection:
Weight:
Interference suppression:
Case including plaster milling machine with base plate, sponge board and
manual.
Application for Indented Purpose
When used with the appropriate equipment, the plaster milling machine
EPG 400 is suitable for machining lime-cement- and gypsum-based
surfaces, for sgraffito purposes and for smoothening insulting boards in the
case of full heat protection.
Available Accessories
Pos. Order No. Article
1 37721000
2 37722000
3 37725000
4 37726000
5 37724000
6 37727000
1
Supply
Base plate (Klett)
Ø 370 mm
Sponge board
Ø 400 mm
Sponge rubber disk
Ø 400 mm
Plaster plane
Ø 385 mm
Scratch disk
Ø 370 mm
Abrasive disk corundum
P24
Ø 370 mm
IP 20
about kg
EN 55014 and EN 61000
basic holder for all Klett
disks
for smoothening lime-
cement-based plasters
for smoothening lime-
cement- and gypsum-based
plasters
for smoothening lime-
cement-based plasters
for sgraffito purposes
for smoothening insulating
boards in the case of full
heat protection
2
12
Application