EIBENSTOCK EPG 400 Notice Originale page 14

stripping down, in case of voltage drop or when fixing or mounting an
accessory.
Switch the machine off if it stops for whatever reason. This way you
avoid that it starts suddenly and not under supervision.
Do not use the machine when one part of the housing is damaged or in
case of damages on the switch, cable or plug.
Check the accessories before use; do not use damaged products.
Before use, make sure that the tool is correctly fixed and fastened.
Let it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
While working, lead the line cord and the extension cord to the back
away from the machine.
Power tools have to be inspected by a specialist in regular intervals.
Never carry the machine at its cable.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the machine.
While working, wear ear protectors, a dust mask and protective
goggles.
Make sure that the persons standing in the work area are not hit by
particles which fly around.
Keep the handles dry, clean and free of oil and grease.
During operation always hold the machine with both hands.
Caution! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
First, check the correspondence between voltage and frequency against
the data mentioned on the identification plate. Voltage differences from
+ 6% to – 10% are allowed.
The EPG 400 is made in protection class II.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small might cause a considerable drop in performance and an
overheating of machine and cable.
Before connecting the machine to the mains supply, make sure that
the machine is switched off.
Electrical Connection
14