Publicité
Les langues disponibles
Les langues disponibles
Switching on and off
Short-Time Operation
Switching-on:
press on/off switch
Switching-off:
release on/off switch
Permanent Operation (only for working with telescopic rod)
Switching-on:
press the on/off switch and, keeping it pressed, engage
the lock button
Switching-off:
press the on/off switch and let it go off again
Attention!
!
In case of every stop of the machine or a power cut, the lock
button has to be released immediately by pressing the
on/off switch. Consequently, you can avoid an unintentional
restart of the machine (physical hazard).
The machine is equipped with an electronic switch. With this switch the
speed can be regulated according to the pressure on the button. Only use
the electronic switch when you want to start the machine slowly for a
optimal surface.
Permanent use with reduced speed can cause an overload because
the motor then gets less cooling air and therefore the machine will be
overheated much faster.
Tool Change
Attention!
Before the beginning of all works disconnect the plug
from the mains!
Mounting the base plate and the scratch disk:
Place the base plate or the scratch disk onto the head spindle and secure it
with the help of the provided screw.
Mounting the work disk:
Place the work disc centrally onto the Velcro plate.
The entire disk must cling to the Velcro plate to ensure that the disk is
attached securely.
Attention!
Before you start working, check whether the accessory has the exact
position. Let the machine start running in a safe position for a short
time.
In case the machine does not run easily, immediately stop
working.
15
Publicité
