Troubleshooting - Deltafox DG-ESS 2844B Traduction De La Notice D'utilisation Originale

Troubleshooting

Problem
Motor not run-
ning or cuts out
during opera-
tion
Garden waste
is not drawn in
Shredding ma-
terial comes
out in chains
Possible cause
Collection box incor-
rectly attached
Overload protection
No mains power supply
Safety switch ( 14)
is not properly in place
on the collector box
( 11)
Cylinder ( 28) run-
ning in reverse
Shredding material is too
soft
Cylinder ( 28) is jammed Free up the jam
Pressure plate (
incorrectly adjusted
Remedy
Insert the collection box (
correctly and move the safety
switch (
as far up as it will go (
To turn it back on, move the direction
switch (
Press the reset switch (
Switch the device back on.
Check the socket, cable, lead and
plug for damage, and if neces-
sary, have any damage repaired
by qualified repair personnel.
Move the safety switch (
into the
emptying the collector box)
Change rotational direction using
the switch
Insert wood or shred dried branches
(See section on working methods)
24) is Readjust the pressure plate
(See section on working methods)
11)
14) on the collection box
position).
1) to the "I" position.
2).
A
14)
position (see section on
GB
33