LG WT1485CW Manuel Du Propriétaire page 25

U
ser Maintenance Instructions
To Clean the Filter in the Inlet Valve
In case the water supply is impure, check substances such as stones or sand in the filter. If the filter is clogged
with dirt, water cannot flow into the washer. Clean the filter regulary. (The figure of power cord and water tap
may vary by country.)
Close the tap before turning off the
1
power. Select both hot/cold and then
press the START/PAUSE button to
remove water remaining in the inlet
hose completely.
After disconnecting the inlet
3
hose, remove the filter from
the inlet valve by hand or
with tools. Then remove dirt
with a brush, or etc.
Caution
Before cleaning the filter, water remaining in the water supply hose should be emptied
To Clean the Lint Filter
1
Pull out the lint filter from
the tub in the direction
shown below.
Note
• If the lint filter is worn out or damaged, contact an LG Service Center for new one.
• The amount of collected lint depends on the load size and type.
Clean the lint filters as necessary.
To Clean the Pump Casing
1 Place a towel on the
floor under the drain
pump cap. Excess
water may flow out.
Caution
Check it if water leaks after reassembling. (The gasket is in the cap.)
2
Turn the net inside out to
remove dirt and rinse it
with water.
2 Turn the cap 3
counter-
clockwise and
pull it out.
Cap
Filter
Turn off the power and
2
disconnect the power
cord.
4
Replace the filter into the water
inlet after cleaning it.
3
Remove any foreign 4
objects and fluff inside
pump casing and from the
filter.
Replace the filter to
the original location.
Push the lip of the filter
until a pop sound is heard.
Replace the cap. Insert the filter along
the guide ribs inside the pump casing.
Filter must face the guide ribs inside
pump casing and securely turn the cap
clockwise.
Guide rib
Filter
25