Important - BABY BOO BB80 Manuel D'utilisation

• Dismantle and clean all parts as instructed in the "CARE AND
CLEANING" section of this manual.
There is a clear protective film on the control panel which can be
•
removed if desired.
Select a level, dry countertop where the appliance is to be used, allowing
•
air space on all sides to provide proper ventilation and a safe distance
from hot surfaces of the appliance.
To prevent damage from steam and heat, ensure the appliance is not
•
placed directly under cupboards when in use.
• Ensure the appliance is always disconnected from the wall power outlet
when not in use.
ASSEMBLING THE BABY FOOD EXPRESS
THE JUG
With the jug lid removed, sit the jug upside down on a flat bench or table.
1.
Ensure the drive shaft gasket is in place over the drive shaft and is
2.
securely sitting at the base of the drive shaft. This will prevent leaking.
Insert the drive shaft into the base of the jug and rotate counterclockwise
3.
while pushing down to lock into place.
IMPORTANT: Always make sure the drive shaft and drive shaft gasket
are properly inserted and locked into the jug before steaming or
blending. Use of the appliance without the drive shaft and gasket will
result in leaking and cause damage to the jug and motor unit.
Turn the jug the right way up and place it onto the motor unit with the
4.
handle directly facing the front over the STOP button. Once seated
securely on the motor unit, rotate counterclockwise until you hear it lock
fully into place.
CAUTION: DO NOT handle by the blade. The blade attachment is very
sharp. Use caution when handling and storing.
Holding the plastic centre of the blade carefully place the blade into the
5.
centre of the jug over the drive shaft and push it to the bottom of the jug.
Add desired ingredients to the jug. Refer to the Quantity and Ingredient
6.
Measurement Recommendations table on page 11.
Place the jug lid onto the jug with the spout cover of the lid at the back
7.
of the jug.
7