Oneida Air Systems Dust Cobra Oneida Vortex DCS Mode D'emploi page 21

Assembly: Cyclone & Filter for Vortex Sander Cyclone
Be careful not to damage filter.
Thumb Nut - AFT000001
Fender Washer 5/16 x1 1/2 - AFW170000
Rubber Washer - AFW381316
Note: During assembly, be sure that
the washer covers the hole in the top
of the filter.
HEPA Filter - VSFSHZ000
Bolt 5/16 x 2 1/2 - AFB155180
Filter Bracket - CVFSSC001
Hex Bolt 5/16 x 3/4 - AFB155175
Washer 5/16 - AFW180000
Sander Cyclone - VRS080112
*Clamp should
be placed so
that the middle
of the clamp
lies on the
seam between
the elbow and
exhaust stack.
Watch for leaks
at this location.
Tighten clamp
if necessary.
90
Elbow
T - Clamp
Connect Cyclone to
Floor Sander Dust Outlet
with Provided T-Clamp.
Connection should be
air-tight.
AFT000001- Thumb Nut (1)
AFW170000 - Fender Washer 5/16 x 1 1/2 (1)
AFW381316 - Rubber Washer (1)
VSFSHZ000 - HEPA Filter (1)
AFB155180 - Bolt 5/16 x 2 1/2 (1)
CVFSSC001 - Filter Bracket (1)
AFB155175 - Hex Bolt 5/16 x 3/4 - (2)
AFW180000 - Washer 5/16 (2)
VRS080112 - Sander Cyclone (1)
Cyclone
Connect Cone outlet to
Flex Hose out to Dust
Cobra.
20
U.S. Pat. #
6,833,016