IMER MOVER 190D Manuel D'utilisation Et D'entretien page 18

Dear Customer,
Congratulations on your purchase: the IMER screed pump, resul-
ting from years of research, offers maximum reliability and features
innovative technical solutions.
- WORKING IN SAFETY.
For safety purposes, make sure to carefully read the fol-
lowing instructions, as well as the instructions given in the
enclosed manuals relevant to the compressor and the Diesel
engine.
This OPERATION AND MAINTENANCE MANUAL must be kept
consultation, together with the user's manuals for the compressor
and the Diesel engine.
The manual should be considered as an integral part of the
machine and must be kept for future reference (EN 12100-2) until
demolition of the machine. If the manual is lost or damaged a copy
can be requested from the manufacturer.
The manual contains the EC declaration of conformity (98/37/EC)
important information on worksite preparation, installation, use,
maintenance and ordering spare parts. In any case, the user
must have adequate experience and knowledge of the machine:
the user must be trained by a person thoroughly familiar with the
machine's use and operating procedures.
To guarantee the operator's safety, safe operation and long life of
the machine, the instructions in this manual must be observed,
together with the current regulations on safety and accident-pre-
vention at work (use of adequate footwear, clothing, dust masks,
gloves, glasses, etc.).
- Make sure warnings are always legible.
systems of the screed pump.
- Always keep the pressurised tank perfectly clean:
report start-up and use of the equipment to the competent
machine; every day make sure the ball valve on the hatch
the equipment periodically checked - at least yearly - by
the competent bodies. The max. design abrasion is 2 mm
for the tank of the MOVER 190 and 4 mm for the tank of the
MOVER 270.
IMER INTERNATIONAL declines any liability in case of improper
tions, and partial or total non-compliance with the instructions
contained in this manual.
1. TECHNICAL DATA
2. DESIGN AND CONSTRUCTION STANDARDS
The pumps are designed and built in accordance with the standar-
ds given in table 1.
3. NOISE LEVEL
Table 1 gives the sound pressure levels of the pump measured
at the operator's ear (LpA at 1 m - 98/37/EC) and the noise level
in the environment (power LWA) measured according to EN ISO
3744 (2000/14/EC).
4. DESCRIPTION OF OPERATION OF SCREED PUMP
- The SCREED PUMP is intended for use in building
sites, for mixing and pumping semidry mixtures for conven-
tional blocks.
IMER INTERNATIONAL S.p.A.
The screed pump has a pressurised tank (ref.3) containing a mixer
(ref.8) operated by a gear motor. The machine is completed by a
wheeled frame (ref.2) with casing, incorporating a screw compres-
sor, complete with electrical panel (ref.5), pneumatic system,
hydraulic system (ref.11).
The machine is supplied with the material delivery pipes (ref.6)
with a jet breaker stand (ref.7).
lar a loading bucket (ref.4). An automatic greasing system (ref.12)
and a hydraulically controlled pressure water cleaner (ref.13) can
also be supplied. The machine can be supplied in the version
approved for towing on roads.
The integrated compressor have a delivery of 2600 Nl/min and a
max. operating pressure of 7 bar.
The material - sand + cement + water - is loaded inside the tank
where it is mixed The hatch is closed and the pumping cycle is
started. The loading and pumping phases follow each other in
succession.
during the pumping phase the wait is used for preparing the next
load of material in the bucket, thus drastically reducing loading
time.
maintenance and, in particular, guarantees constant greasing of
the mixer supports.
The pressure water cleaner enormously facilitates end of day
machine cleaning operations.
placing operations.
-
20
-