Alarm Display - Panasonic DG-DV2500E Mode D'emploi

ON-SCREEN DISPLAY
Alarm display : Alarm messages are displayed as shown below, when an operation error
Display at position A : Displays which show the state of the unit continues to be displayed
Display
LOW VOLTAGE
HEAD CLEANING
REQUIRED!
NO DV SIGNAL
Display at position B : Messages indicating operation errors are displayed for about 3 sec-
Display
INVALID TAPE!
LP TAPE!
DV NOT CONNECT
E-22
has occurred or when the unit is in a poor condition for operation. E.g.,
dirty head.
3 2 K C H – 1 / 2
A
H E A D C L E A N I N G R E Q U I R E D !
B
I N V A L I D T A P E !
1 0 / 1 0 / 0 2
1 2 : 0 0 : 0 0
here until the conditions are rectified.
The voltage of the DC input power is low. Continued operation will bring the unit to the
POWER OFF mode.
Displayed irrespective of the DISPLAY mode setting.
The video head is dirty. Please clean it with the dedicated head-cleaning tape.
( ☞ Page 8)
If the head is clogged, it will be detected in the PLAYBACK mode and displayed.
When the unit enters the STOP mode or the cassette is ejected, the display goes off.
Displayed irrespective of the DISPLAY mode setting.
Despite DV connection, signals are not received.
Displayed when DISPLAY mode is set to ON/AUTO.
onds.
They are displayed when the DISPLAY mode is ON or AUTO.
Data tapes for PC use or DVC PRO tapes has been inserted.
The cassette will be ejected.
The user attempts to play back a tape recorded in the LP mode.
This unit cannot record or play in the LP mode.
DV connection is not done.
0
m i n
S T A N D B Y - O F F
T C R 0 2 : 0 0 : 0 0 : 0 0
Contents
Contents
– Alarm display –