Ergomotion 390 Série Mode D'emploi page 17

setting up two bases
If simultaneous operation of two bases is desired, use the SmartSync
STEP 1
Unplug base from power source .
STEP 2
Disconnect the power-down box cable from each control box .
Make note where the cable was plugged in .
STEP 3
Connect the male end of the sync cord to each control box . Insert it
into the same port that you disconnected the power down box from
in Step 2 .
Control Box
Power-Down Box
electronics of both bases together.
STEP 4
Connect each power-down box male connection to the sync cord
female connection (Refer to the illustration below) .
STEP 5
Plug base back into the power source .
STEP 6
Check to ensure all cords are securely attached . Both remotes will
now operate both bases simultaneously (If the remotes become
unpaired, see page 14) .
Sync Cord
Splitter
Splitter
Cord to connect the
™
SERIAL PORT SERIAL PORT
Control Box
Power-Down Box
15