Emergency Power Down Box - Ergomotion 390 Série Mode D'emploi

emergency power down box

In the event that the base is stuck in an articulated position during a power outage- the Power
(2) 9 Volt batteries are required to operate the power down feature and are NOT included.
STEP 1
Locate the Power Down Box under the base .
12
Down Box will return the base to a flat position.
STEP 2
Press and hold the button until the base is flat.
Note: The light will turn off after several minutes, however the
button can be pressed at any time during the loss of power to
bring the base flat.
For emergency use only .
The Power Down Box can only be used to bring the base to a
flat position. It will not bring the base to a flat position when
the base is connected to a working power source .