Ergomotion 390 Série Mode D'emploi page 4

safety precautions and usage statements
smothering risk to small children and pets. To avoid injury, it is not
advised to allow children and small pets to play on or under the bed.
Children should not operate the bed base without adult supervision.
Safety Features:
Casters (optional leg accessory) are equipped with locking wheels to
prevent unwanted movement. Even when locked and unable to roll, it is
possible for the casters to slide. Free release head and foot motors are
designed to lower the mattress by retracting only with gravity, never
pulling downwards, which minimizes pinch points.
Product Ratings:
The lift motors are not designed to operate continuously for more than
[2] minutes in an [18] minute time period or approximately 10% duty
cycle. Attempting to circumvent or exceed this rating will shorten the life
expectancy of the product and may void the warranty.
Weight Limits:
This product is not rated to support weights exceeding 850 pounds.
This product is not rated to support weights in excess of 850 pounds
inclusive of the mattress and bedding. The base will structurally
support this weight, provided it is evenly distributed across the
bed base. The adjustable base is not designed to support or lift this
amount in the head or foot sections alone. Exceeding this weight
restriction could damage the bed and/or cause injury and will void
the warranty.
2
Acoustics:
The massage function will emit a noticeable tone during operation.
As the massage intensity level is increased, the tone will intensify. The
volume of this tone is directly related to the location environment.
For example, when demonstrated in a show room, the surrounding
environmental noise will cover some of the massage noise. However,
when installed in a home setting with wooden floors, carpeted or not,
the massage volume will be more noticeable.
In normal base operation, the wheels which allow the bed to maintain
its distance from the wall, will make contact with the steel platform
supports of the base creating a contact noise. When entering, exiting
or shifting weight on the base, this contact noise may be audible as
the wheels make contact. This is normal.
SAVE THESE INSTRUCTIONS.
FCC Compliance:
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
To comply with the FCC RF exposure requirements, no change to
the antenna or the device is permitted. Any change to the antenna
or the device could result in the device exceeding the RF exposure
requirement and void user's right to operate the device.
Radio Frequency: 2.4 GHz