Operating And Maintenance Instructions For The User; Warnings; Initial Start-Up; Recommendations - CHAFFOTEAUX AQUANEXT PLUS 200 Instructions D'utilisation

OPERATING AND MAINTENANCE INSTRUCTIONS FOR THE USER

6. WARNINGS

6.1 Initial start-up

WARNING! The installation and initial start-up of the appliance must be performed by qualified
personnel in compliance with the national regulations in force regarding installation, and in
conformity with any regulations issued by local authorities and public health bodies.
In all cases, the company performing the work must carry out checks to verify the safety and correct
operation of the entire system.
Before starting the water heater, check that the installer has completed all of his operations. Make sure you fully
understand the installer's explanations on operation of the water heater and correct performance of the appliance's
main operations.

6.2 Recommendations

In the event of a malfunction and/or faulty operation, turn the appliance off and do not attempt any repairs, but contact
qualified personnel. Only original spare parts must be used and any repairs must be carried out exclusively by
qualified personnel. Failure to comply with the above-mentioned recommendations may jeopardise the appliance's
safety and void the manufacturer's liability. In the event of prolonged inactivity of the water heater, it is advisable to
carry out the following:
- Disconnect the appliance from the power supply or, if a switch is mounted upstream from the appliance, turn the
switch itself to the "OFF" position.
- Close all taps of the domestic water supply system.
- Empity the product as shown par. 8.1
WARNING! Hot water at temperatures above 50°C running from taps may immediately cause serious burns.
Children, the disabled and the elderly run a greater risk in this regard. Therefore, it is advisable to use a
thermostatic mixing valve connected to the appliance's water outlet pipe.
CAUTION If the display shows the icon to the side, it means that the water temperature has
reached a temperature more than 6°C above the temperature set.
It is mandatory to have a mixing valve in the SYS models.
CAUTION! (only for SYS versions) Ensure that the temperature detected by the S2, S3 sensors of the auxiliary
source's control unit, inside the water heater, do not exceed 75°C. fig.15.

6.3 Safety regulations

Refer to paragraph 1.1 for the description of the symbols used in the table below.
Ref. Warning
Do not perform operations that involve
1
removing the appliance from its housing.
Do not leave objects lying on the
2
appliance.
3 Do not climb onto the appliance.
Type of risk
Electrocution due to exposure to live components.
Flooding caused by water leaking from disconnected
piping.
Personal injury caused by the object falling off the
appliance as a result of vibrations.
Damage to the appliance or any underlying items
caused by the object falling off as a result of
vibrations.
Personal injury caused by the appliance falling down.
Damage to the appliance or any underlying objects
caused by the appliance detaching from its fixing
brackets and falling.
74
Symbol