Symbols Used; Overview Operational Controls; Overview Display Version Main Screen; Precautionary Measures And Safety Instructions - Brink WTW control Mode D'emploi

II Symbols used
Warning! The user can (seriously) injure himself or
seriously damage the product.
A warning is indicative of a risk of damage to the user
or product, if the user does not execute the procedures
carefully.
Careful! The product can be endangered. "Careful" is
indicative of a risk of damage to the product, if the user
does not execute the procedures carefully.
Take note! A remark with supplementary information
for the user. A remark draws the user's attention to
possible problems.
Product description
Name:
Model/Type:
Electricity
Power consumption:
Protection class:
Power reserve:
Ambient conditions
Ambient temperature:
Storage temperature:
Humidity:
Other:
The WTW control should be placed and used in a space with
the correct ambient conditions for proper operation. The WTW
control may only be mounted on the indoors, but not on the
vicinity of a heat source, a radiator, in a draft or in a humid
environment. The WTW control may also not be exposed to
direct radiation heat (sun light).
The WTW control may also not be mounted in the vicinity of a
1.3 Overview operational control
The WTW control has a number of buttons with which the de-
vice can be operated:
Navigation button
1
2 Return button
3 Device selection button
Manual operation button
4
Info button
5
Left setting button
6
Take note! The left setting button
left beside the display have no function in this type of WTW
control.
WTW control
Brink Climate Systems
15 to 24 Volt
3 Watt
IP30
> 48 hours
0 °C to 50 °C
-20 °C to 60 °C
10% to 90%
Exclusively for indoor use
1
and the marking
6

1.4 Overview display version main screen

Ventilation position indicator
1
Ebus indicator
2
Ventilation indicator
3
4 Failure symbol
5
Programme period mode
6
Current day
7
Device selection
8
Date and time representation
9
1.5 Ventilation modes
The WTW control has four ventilation modes. You can activate
a ventilation mode yourself (for more information see chapter
4). You can adjust every ventilation mode yourself (for more
information see paragraph 4.7).
You can retrieve the set values by pressing the info button
1
(see ).
2 Precautionary measures and safety
instructions

2.1 General

Warning! The installation and assembly activities
required to commission your WTW control should be
performed by an installer approved by Brink Climate
Systems.
Warning! Immediately remove the power from your
WTW control by removing the connected device's plug
from the socket, if:
Parts of the WTW control lie open, are pierced or
had fallen hard;
The power cable is damaged;
The screen is cracked or broken.
Then contact Brink Climate Systems or you supplier.
Take note! Never use parts other than original parts.
Take note! Only use the WTW control indoors, at tem-
peratures between 0 °C and 50 °C and with a relative
humidity between 10% and 90%.
Take note!
will be lost if the WTW control breaks down or if the fac-
tory settings are reset. There is no backup available.

2.2 During placement

Take note! Assembly and installation should be per-
formed by an installer approved by Brink Climate
Systems. The following requirements should be taken
into account during placement:
6
2
3
5