Symbols Used; Technical Specifications; General Product Specifications; Environmental Influences - Brink WTW Mode D'emploi

functioning. These devices' presence and proper functioning
are prerequisites for using the WTW control. See appendix 1
for an overview and explanation.
II Symbols used
Warning! The user can (seriously) injure himself or
seriously damage the product.
A warning is indicative of a risk of damage to the
user or product, if the user does not execute the
procedures carefully.
Careful! The product can be endangered. "Careful"
is indicative of a risk of damage to the product, if the
user does not execute the procedures carefully.
Take note! A remark with supplementary information
for the user. A remark draws the user's attention to
possible problems.

1 Technical specifications

1.1 General product specifications

Product description
Name:
Model/Type:
Technical product specifications
Electricity
Power consumption:
Protection class:
Power reserve:
Ambient conditions
Ambient temperature:
Storage temperature:
Humidity:
Other:

1.2 Environmental influences

The WTW control should be placed and used in a space
with the correct ambient conditions for proper operation.
The WTW control may only be mounted on the indoors, but
not on the vicinity of a heat source, a radiator, in a draft or
in a humid environment. The WTW control may also not be
exposed to direct radiation heat (sun light).
The WTW control may also not be mounted in the vicinity of
a magnetic field. This could damage internal components.
1.3 Overview operational control 1
The WTW control has a number of buttons with which the
device can be operated:
Navigation button
1
Return button
2
Device selection button
3
Manual operation button
4
Info button
5
Left setting button
6
WTW control
Brink Climate Systems
15 to 24 Volt
3 Watt
IP30
> 48 hours
0 °C to 50 °C
-20 °C to 60 °C
10% to 90%
Exclusively for indoor use
Take note! The left setting button
left beside the display have no function in this type of WTW
control.

1.4 Overview display version main screen 2

Ventilation position indicator
1
Ebus indicator
2
Ventilation indicator
3
Failure symbol
4
Filter notification
5
Programme period mode
6
Current day
7
Device selection
8
Date and time representation
9
1.5 Ventilation modes 3
The WTW control has four ventilation modes. You can
activate a ventilation mode yourself (for more information see
chapter 4). You can adjust every ventilation mode yourself
(for more information see paragraph 4.7).
You can retrieve the set values by pressing the info button
(see 1 ).
2 Precautionary measures and safety
instructions

2.1 General

Warning! The installation and assembly activities
required to commission your WTW control should be
performed by an installer approved by Brink Climate
Systems.
Warning! Immediately remove the power from your
WTW control by removing the connected device's
plug from the socket, if:
• Parts of the WTW control lie open, are pierced or
had fallen hard;
• The power cable is damaged;
• The screen is cracked or broken.
Then contact Brink Climate Systems or you supplier.
Take note! Never use parts other than original parts.
Take note! Only use the WTW control indoors, at
temperatures between 0 °C and 50 °C and with a
relative humidity between 10% and 90%.
Take note! All settings (excluding the filter message)
will be lost if the WTW control breaks down or if
the factory settings are reset. There is no backup
available.

2.2 During placement

Take note! Assembly and installation should be
performed by an installer approved by Brink Climate
Systems. The following requirements should be taken
into account during placement:
6
and the marking
6
5