DeWalt DCMW220 Guide D'utilisation page 12

English

WARNING: Let the mower work at its own pace. Do
not overload.
Adjusting Mower Height (Fig. I)
The height of cut is adjusted by the central cut height adjust
lever.
nOTE: If you are not sure which height to cut, begin
mowing with the cut height adjustment lever
positioned towards the rear of the appliance and adjust the
height down as needed, as shown in Fig. I.
To Set the Height of Cut
1. Pull the cut height adjustment lever
locking notch 17 .
2. Move the lever towards the rear of the appliance to raise
the height of cut.
3. Move the lever towards the front of the appliance to
lower the height of cut.
4. Push the height adjustment lever into one of the
locking notches.
Fig. I
17
Safety Key (Fig. J)

DANGER: Sharp moving blade. In order to prevent
accidental start-up or unauthorized use of your
Cordless Mower, a removable safety key
incorporated into the design of your mower. The
mower will be completely disabled when the safety
key has been removed from the mower.
nOTE: The safety key has a hole in the center to allow
for storage on a nail, out of the reach of children. do
not tether safety key to mower.

DANGER: Rotating blades can cause serious
injury. To prevent serious injury, remove safety
key and battery packs when unattended,
or when charging, cleaning, servicing,
transporting, lifting, or storing mower.
10
Fig. J
10
10 out of the
Starting Mower (Fig. K, L)

nOTE: Mower is operational when batteries and safety key
are installed.
1. Insert safety key
it is fully seated inside housing as shown in Fig. K. The
mower is now operational.
2. Your mower is equipped with a special ON-OFF switch
box
ON-OFF button
pull the bail handle
in Fig. L. Once the mower starts you can release
10
the ON-OFF button.
3. To turn the mower OFF, release the bail handle

nOTE: Once the bail handle has returned to the original
position it will activate the "Automatic Braking Mechanism".
The motor is electrically braked and the mower blade will
stop rotating in three seconds or less.
Fig. K
3 has been
3
DANGER: Sharp moving blade. Never attempt
to override the operation of this switch box and
safety key system as serious injury could result.
3 into the ON-OFF switch box
. To operate the mower, push and hold the
1
on the ON-OFF switch box
2
5 to the handlebar as shown
WARNING: Never attempt to lock a switch or bail
handle in the ON position.
3
1 until
, then
1
5 .
1