Storage Recommendations - DeWalt DCMW220 Guide D'utilisation

English
b. Check to see if receptacle is connected to a light
switch which turns power off when you turn out the
lights;
c. Move the charger and battery pack to a location
where the surrounding air temperature is
approximately 65 °F – 75 °F (18 ° – 24 °C);
d. If charging problems persist, take the tool, battery
pack and charger to your local service center.
4. The battery pack should be recharged when it fails to
produce sufficient power on jobs which were easily
done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may
also charge a partially used pack whenever you desire
with no adverse effect on the battery pack.
5. Foreign materials of a conductive nature such as, but
not limited to, grinding dust, metal chips, steel wool,
aluminum foil, or any buildup of metallic particles
should be kept away from charger cavities. Always
unplug the charger from the power supply when there
is no battery pack in the cavity. Unplug the charger
before attempting to clean.
6. Do not freeze or immerse the charger in water or any
other liquid.

Storage Recommendations

1. The best storage place is one that is cool and dry, away
from direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
Intended Use
This lawn mower has been designed for professional lawn
mowing applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This lawn mower is a professional lawn care appliance.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
8
ASSEMBLY

DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and
remove battery packs before assembly, making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Adjusting Handle Height (Fig. D, E)
The mower is shipped in storage mode. You will need to
adjust the handle to operating position before continuing.
1. To unlock the handle 4 from storage position, pull and
twist a half turn the two handle locks
sides of the handle as shown in Fig. D.
2. Raise the handle to operating position.
3. Locate the two handle detent holes
handle brackets 7 as shown in Fig. E.
4. Adjust the handle to the position that best fits the
operator and lock the handle in place by untwisting the
handle locks allowing them to snap into the desired
6
detent holes.
Fig. D
Fig. E
Grass Collection Bag (Fig. F)

DANGER: Remove safety key and battery packs before
removing mulching insert, and when opening rear
door cover and installing bag.
1. Ensure the mulching insert
the mower before proceeding to step 2.
2. Lift the rear door cover
11
collection bag onto the mower so the bag
12
hooks 18 rest on the lugs
lower the rear door cover.
located on both
6
16 located on the
4
6
16
7
22 (Fig. G) is removed from
and place the grass
21 as shown in Fig. F. Then