Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000187-001.book Page 12 Thursday, January 29, 2015 1:11 PM
en
12
Extension cable.
If the use of an extension cord
WARNING
is required, its length and con-
ductor cross-section must be adequate for the
application in order to prevent a voltage drop
in the extension cord, power loss and over-
heating of the power tool. Otherwise, the
extension cable and power tool are prone to
electrical danger, and the working efficiency is
decreased.
Intended use of the power tool:
Hand-guided straight grinder for dry grinding
of metal with small grinding accessories
(grinding points) for shaping metal with hard
metal cutters and for cut-off grinding.
Operation of the power tool off power generators.
This power tool is also suitable for use
with AC generators with sufficient power
output that correspond to the Standard
ISO 8528, design type G2. This Standard is
particularly not complied with when the so-
called distortion factor exceeds 10 %. When
in doubt, please refer to the generator
instruction/specification guide.
Recommended dimensions of extension
cables at an operating voltage of 120 V – sin-
gle-phase a. c., with only one power tool
GSZ4-280EL, GSZ4-90EL, GSZ8-280P,
GSZ8-280PE, GSZ8-280PL, GSZ8-280PEL,
GSZ8-90PEL, GSZ11-320PRL, GSZ11-320PERL,
GSZ11-90PERL connected:
Max. cable length, ft
Max. cable length, m
≤ 100
100
200
–200
–300
Min. conductor size
Min. conductorcross-
A.W.G.
section, mm
16
14
12
GSZ8-90PEL, GSZ11-90PERL, GSZ4-90EL:
These power tools are additionally intended
for brushing and polishing in weather-pro-
tected environments with the accessories rec-
ommended by FEIN.
Operating the power tool off
WARNING
power generators whose no-
load speed exceeds the voltage value on the
type plate of the power tool is prohibited.
≤ 30
30
60
– 60
–100
2
1.5
2.5
4
Publicité
