Level Dryer; Adjust Leveling Legs - Whirlpool HYBRIDCARE Instructions D'installation

LEVEL DRYER

1.
Level dryer
Place
level here
Check levelness of dryer from
side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture-sensing
system to operate correctly. If forward slope of dryer is
greater than 1" (25 mm), water could run out from front
of filter.
Not Level
2.

Adjust leveling legs

If dryer is not level, prop up using a wood block, use a wrench
to adjust legs up or down, and check again for levelness.
Once dryer is level, make sure all four legs are snug against
the floor and dryer does not rock.
LEVEL
Not Level
3.
Plug into a grounded 3 prong outlet
4.
Check for leaks
While running the first cycle, check that there are no leaks
from the drain hose.
15