Level Dryer; Adjust Leveling Legs - Whirlpool WED4850HW Manuel D'instructions

LEVEL DRYER

1.
Level Dryer
Place
level here
Place
level here
Check levelness of dryer from side to side. Repeat from
front to back.
NOTE: The dryer must be level for the moisture sensing
system to operate correctly.
Not Level
2.

Adjust leveling legs

If dryer is not level, prop up using a wood block. Use wrench to
adjust legs up or down, and check again for levelness.
20
LEVEL Not Level
3.
Base trim (on some models)
To Install:
Locating
Pins
Place the base trim to bottom of dryer and match the
locating pins with the holes. Press the base trim firmly
upwards until it snaps into place.
To Remove:
On each corner. 1) Push down on top of base trim.
2) Rotate away from dryer and remove.
Locking
Features