Complete Installation Checklist; Door Reversal (Optional) - Whirlpool HYBRIDCARE Instructions D'installation

COMPLETE INSTALLATION
CHECKLIST
Ɨ Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
Ɨ Check that dryer is level. See "Level Dryer."
Ɨ Check that you have all of your tools.
Ɨ Dispose of/recycle all packaging materials.
Ɨ Check dryer's final location.
Ɨ Remove film on console and any tape remaining on dryer.
Ɨ Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
Ɨ Read "Dryer Use" in your Use and Care Guide.
Ɨ For power supply cord installation, plug into a grounded
outlet. For direct wire installation, turn on power.
Ɨ Select a Timed Dry heated cycle and start dryer.
If dryer will not start, check the following:
• Controls are set to a running or On position.
• Start button has been pressed firmly.
• Dryer is plugged into an outlet and/or electrical
supply.
• Household fuse is intact and tight or circuit breaker
has not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
NOTE:
You may notice an odor when dryer is first heated.
This odor is common when heating element is first used.
The odor will go away.
16

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with round doors.
Tools needed:
Min. 8" (203 mm) long
TORX , T20 and T25
® ® ®
screwdrivers
DOORS WITH LCD SCREEN:
1.
Disconnect wiring from door
Using a Phillips screwdriver, remove middle screw in hinge.
Disconnect wiring. Tuck wiring into opening.
† TORX, T20, and T25 are registered trademarks of Acument Intellectual Properties, LLC.
®
#2 Phillips screwdriver
†