Stanley ST-45-KFA-E Mode D'emploi page 17

RISK OF ELECTRIC SHOCK! DISCONNECT FROM pOWER BEFORE MAINTENANCE.
WARNING
NOTE: This section only applies to heaters sold or used in Great Britain.
This appliance is supplied with a BS1363 3 pin
plug fitted with a fuse. Should the fuse require
replacement, it must be replaced with a fuse with the
proper amp rating. (see Technical Specifications page
2) and approved to BS1362.
In the event the mains plug has to be removed/
replaced for any reason, please note:
IMpORTANT: The wires in the mains lead are colored
in accordance with the following code:
Blue – Neutral
Green/Yellow – Earth
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows:
© 2014, Pinnacle Products International, Inc.
plug Replacement
Brown – Live
plug Replacement Wiring Diagram
BLUE
Neutral
CORD CLAMP
The blue wire must be connected to the terminal
marked with an N or colored black. The brown wire
must be connected to the terminal marked with an
L or colored red. The green/ yellow wire must be
connected to the earthing terminal which is marked
with an E or with the earth symbol.
WARNING
the plug.
NOTE: If a moulded plug is fitted and has to be
removed take great care in disposing of the plug
and severed cable, it must be destroyed to prevent
engaging into a socket.
GREEN / YELLOW
Earth
16
Never connect live or neutral
wires to the earth terminal of
BROWN
Live
FUSE
5 Amps