Table Des Matières - Titan Tool Elite 3000 Mode D'emploi

ELITE 3000
1 SAFETY REGULATIONS FOR AIRLESS
SPRAYING ______________________________ 4
1.1 Explanation of symbols used _____________________4
1.2 Grounding instructions _________________________4
1.3 Safety hazards ________________________________4
1.4 Setup on an uneven surface _____________________7
2 OVERVIEW ______________________________ 8
2.1 Application ___________________________________8
2.2 Coating material ______________________________8
2.2.1 Coating materials with sharp-edged additional
materials _____________________________________8
2.2.2 Filtering _____________________________________8
2.3 Sprayer configurations _________________________9
3 DESCRIPTION OF UNIT __________________ 10
3.1 Airless process _______________________________10
3.2 Functioning of the unit ________________________10
3.3 Explanatory diagram __________________________11
3.4 Adjusting the handle __________________________12
3.5 Technical data _______________________________12
4 STARTUP ______________________________ 13
4.1 Unit with suction system _______________________13
4.2 Unit with upper hopper ________________________13
4.3 High pressure hose and spray gun _______________13
4.4 Connection to the mains network _______________13
4.5 Cleaning preserving agent when starting-up of
operation initially _____________________________14
4.6 Ventilate unit (hydraulic system) if the sound of
inlet valve is not audible _______________________14
4.7 Taking the unit into operation with
coating material ______________________________14
5 SPRAYING TECHNIQUE __________________ 15
5.1 Cleaning a clogged tip _________________________15
6 HANDLING THE HIGH-PRESSURE HOSE ____ 16
7 INTERRUPTION OF WORK ________________ 16
8 CLEANING THE UNIT ____________________ 17
8.1 Cleaning the unit from the outside _______________18
8.2 Suction filter _________________________________18
8.3 High-pressure filter ___________________________18
8.4 Cleaning the Airless spray gun __________________19
9 SERVICING _____________________________ 19
9.1 General servicing _____________________________19
9.2 High-pressure hose ___________________________19
10 REPAIRS AT THE UNIT ___________________ 20
10.1 Inlet valve pusher _____________________________20
10.2 Inlet valve ___________________________________20
10.3 Outlet valve _________________________________21
10.4 Pressure control valve _________________________21
10.5 Replacing the power cable _____________________22
10.6 Typical wear parts ____________________________22
10.7 Connection diagram __________________________22
10.8 Remedy in case of faults _______________________24
WARRANTY _________________________________ 25
SPARE PARTS AND ACCESSORIES _____________ 74
Spare parts list for main assembly __________________ 74/75
Spare parts list for cart assembly ___________________ 76/77
Spare parts list for motor / pump assembly __________ 78/79
Spare parts list for pump assembly _________________ 80/81
Spare parts list for outlet valve assembly _______________82
Spare parts list for pusher stem assembly _______________83
Spare parts list for flexible suction system ______________84
Spare parts list for rigid suction system ________________85
Spare parts list for filter assembly (optional) _____________86
Spare parts list for hopper (optional) __________________87
ACCESSORIES ____________________________ 88/89
CONTENTS
3