Startup; Unit With Suction System; High Pressure Hose And Spray Gun; Connection To The Mains Network - Titan Tool Elite 3000 Mode D'emploi

ELITE 3000
4

STARTUP

Press the inlet valve inside the coating material
i
inlet (4) downwards before starting the
operation. This ensures that the valve is not
blocked or clogged.
4.1
UNIT WITH SUCTION SYSTEM (A)
1. Ensure that the sealing surfaces of the connections are
clean.
Ensure that the red inlet (1) is inserted in the coating
material inlet (4).
2. Use the enclosed 41 mm wrench to screw the union nut
(2) at the suction hose (3) onto the coating material inlet
(4) and tighten it.
3. Screw the union nut (5) at the return hose (6) to the
connection (7) (22mm).
A
3
2
9
4.2
UNIT WITH OPTIONAL HOPPER (B)
The pail bracket will need to be removed in order
i
to install the hopper to the unit.
1. Ensure that the sealing surfaces of the connections are
clean. Ensure that the red inlet (1) is inserted in the coating
material inlet (4).
2. Screw the union nut (5) on the return pipe (6) onto the
connection (7).
3. Screw the upper hopper (8) onto the coating material inlet
(4).
B
8
9
11
6
4.3
5
1. Screw the high pressure hose (9) onto the hose connection
7
2. Screw the spray gun (10) onto the high pressure hose
1
3. Tighten all union nuts on high pressure hose so that no
4
coating material can escape.
4. Screw the tip holder with the selected tip onto the spray
gun, align tip and tighten union nut.
10
5. Fully depress the pusher stem (11) to make sure the inlet
ball is free.
Attention
4.4
Attention
Before connecting the unit to the mains supply, ensure that the
line voltage matches that specified on the unit's rating plate.

HIGH PRESSURE HOSE AND SPRAY GUN

When unscrewing the high pressure hose, hold
firmly on the hose connection with a 22mm
wrench.

CONNECTION TO THE MAINS NETWORK

Connection must always be carried out via
an appropriately grounded safety outlet with
residual-current-operated circuit-breaker.
STARTUP
6
4
11
7
1
4
10
13