Cleaning The Unit From The Outside; Suction Filter; High-Pressure Filter - Titan Tool Elite 3000 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CLEANING THE UNIT
8.1

CLEANING THE UNIT FROM THE OUTSIDE

Danger of short-circuits caused by water
ingression!
Never spray down the unit with high-pressure or
high-pressure steam cleaners.
Do not put the high-pressure hose into solvents.
Use only a wet cloth to wipe down the outside of
the hose.
Attention
Wipe down unit externally with a cloth which has been
immersed in a suitable cleaning agent.
8.2

SUCTION FILTER

Clean filters always ensure maximum volume,
i
constant spray pressure and problem-free
functioning of the unit.
1
SUCTION SYSTEM
UNIT WITH SUCTION SYSTEM
1. Unscrew the filter (Item 1) from the suction tube.
2. Clean or replace the filter.
Carry out cleaning with a hard brush and a corresponding
cleaning agent.
UNIT WITH OPTIONAL HOPPER
1. Remove screws with a screwdriver (Item 2).
2. Lift and remove filter disk (1) with a screwdriver
3. Clean or replace the filter disk.
Carry out cleaning with a hard brush and a appropriate
cleaning agent.
18
2
1
HOPPER
8.3
HIGH-PRESSURE FILTER (OPTIONAL)
1. Set pressure relief valve to
2. Switch the pump OFF using the ON/OFF switch (Pos. 0).
3. Open the high-pressure filter and clean the filter insert. To
do so:
4. Unscrew the filter housing (1) by hand.
5. Remove the filter insert (2) and pull out the bearing spring
(3).
6. Clean all the parts with the corresponding cleaning agent.
If compressed air is available – blow through the filter
insert and bearing spring.
7. When mounting the filter ensure that the bearing ring (4)
in the filter insert is positioned correctly and check the
O-ring (5) at the filter housing for damage.
8. Screw on the filter housing by hand until it stops (a higher
tightening force only impedes later dismantling).
1
2
ELITE 3000
(pressure relief, circulation).
4
3
5

Publicité

Table des Matières
loading

Table des Matières