Functional Description - Makita 9032 Manuel D'instruction

hazardous substances. Use appropriate respira-
tory protection.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety
rules stated in this instruction manual
may cause serious personal injury.
SYMBOLS
The followings show the symbols used for tool.
V............................volts
A ...........................amperes
Hz..........................hertz
...................alternating current
.......................Class II Construction
m/s........................meter per second
ft/min ....................feet per minute

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Adjusting arm inclination
The arm can be pivoted and fixed at any desired angle
within the "A" range according to the operating position or
the figure of the workpiece.
1
2
"A" range
Loosen the lock lever by raising it. Pivot the arm to the
desired position, and secure the lock lever to fix the arm
firmly.
Replacing arm
By replacing the standard-equipped arm by optional one,
6 mm (1/4") or 13 mm (1/2") width belt can be used.
Remove the arm by loosening the screw that secures the
USD204-3
001215
1. Lock lever
2. Arm
arm. Insert the arm that fits the belt to be used, and
tighten the screw firmly.
1 2
Switch action
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
1
2
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed adjusting dial
1
The belt speed can be infinitely adjusted between 5 m
and 28 m per second (980 - 5600 ft./min.) by turning the
speed adjusting dial to a given number setting from 1 to
6.
Higher speed is obtained when the dial is turned in the
direction of number 6; lower speed is obtained when it is
turned in the direction of number 1. Select the proper
speed for the workpiece to be sanded.
4
001216
1. Screw
2. Arm
001217
1. Lock button
2. Switch trigger
001218
1. Speed adjust-
ing dial