dirna Bergstrom bycool blue line FLAT 24V Instructions De Montage page 24

FLAT
ES
EN
Position the interior air distribution panel
9
on the front studs with (1) M6 wide-rimmed
washer and (1) M6 nut on each stud. Tighten
the nuts until the duct units come up against
the unit's upper foam.
Important: The channellers must meet
the rubber to avoid air leaks.
9
EPDM
Seal
Cab roof
Upholstered
Tighten the nut in point 9a until it comes
10
up against the top part of the interior air
distribution panel.
10
EPDM
Seal
Cab roof
M6 Stud bolt
Upholstered
Place the console and centre the equipment
11
on the most suitable place on the cab roof.
Once centred remove the console.
Bycool Base
M6 Nut
M6 Stud bolt
Bycool Base
M6 Nut (8a)
M6 Nut
(A)
Channellers
Channellers
24
Air conditioning for vehicles
Foam
Interior air distribution
panel
Foam
Interior air distribution
panel