Polarized Plug; Dry-Vacuum Operation - Dura Vac CVBV1211PWT Manuel D'utilisation

14. Insert the hose holder into the provided slot. (fig. 15)
15. Choose the desired accessories and push onto the suction tube. (fig. 16)
NOISE DIFFUSER
For quiet operation during vacuuming, install the noise diffuser into the blower port by
inserting the locking end of the diffuser into the blower port and turning clockwise to lock
into place.

POLARIZED PLUG

To reduce the risk of electrical shock, this appliance has a polarized plug (one with the blade wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the
plug in any way. Double insulation
grounded power supply system.

DRY-VACUUM OPERATION

DRY VACUUM
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED 'SAFETY
WARNING:
INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT
LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. In order to prepare your vacuum for dry vacuuming, verify that the cartridge filter is securely mounted.
With power head removed and in upside down position, make sure the filter is pushed in until it stops
against the power head and the retainer is installed. (fig. 2 & 3) (Your Wet/Dry Vac comes with the
cartridge filter pre-installed, if not, see page 10 for installation instructions.)
3. Optional, for improved dust filtering, fit collection bag flange onto the inlet stub, taking care not to damage
the bag. (fig. 4)
4. Place the power head back on the container, and secure it in place using the latches. (fig. 5)
OPERATING INSTRUCTIONS: DRY VACUUMING
6. Insert the locking end of the hose into the vacuum port and lock in place. Push the required attachment
onto the free end of the hose or extension. (fig. 6)
7. Plug in the power cord into the outlet. (fig. 7)
8. Turn the motor on by flipping the switch to the 'I' ON position. (fig. 8)
9. Once you have completed vacuuming, flip the switch to the 'O' OFF position and unplug the power cord
from the outlet.
eliminates the need for the three wire grounded power cord and