General Assembly Instructions - Dura Vac VF410P 0501 Manuel D'utilisation

GENERAL ASSEMBLY INSTRUCTIONS

WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Undo the latches. (fig. 2)
3. Lift the power head off the container. (fig. 3)
4. Remove the contents from inside the container, make sure you have all contents as listed on page 5.
(fig. 4)
5. Your vacuum comes ready for dry vacuum cleaning. If cartridge filter is not installed refer to page 10 for
filter installation. (fig. 5 & 6)
6. For wet vacuum cleaning, install the supplied foam filter. (fig. 7) See page 10 for filter installation.
7. Place the power head back on the container, aligning the top section with the latches, and snap into
place. (fig. 8)
8. Secure the large end of the hose onto the vacuum port on the container and screw into place. (fig. 9)
9. Choose the desired accessories and insert onto the end of the hose. (fig. 10)
AIR / NOISE DIFFUSER
To diffuse exhaust air or for quieter operation,
install the noise diffuser into the blower port
by turning clockwise to lock into place.
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one with the blade wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the
plug in any way. Double insulation
grounded power supply system.
eliminates the need for the three wire grounded power cord and
6