Starting A Warm Engine; Starting A Flooded Engine; Stopping The Engine; Trimming - Little Wonder 2230S Manuel D'instructions

OPERATION
2. Pull choke knob out to COLD START (closed) position.
3. Push primer bulb 3 to 4 times, or until fuel is visible
in the clear fuel return line.
4. Pull starter rope until engine sputters. Use short pulls,
1/2 to 2/3 of the rope length.
Avoid accidental blade engagement.
Do not squeeze trigger when starting.
Maintain engine's proper idle speed adjustment
(2500 - 2700 rpm)
Max full throttle engine speed is 10,500 – 11,000 rpm
5. Push choke knob in to the RUN position.
6. Restart engine and allow it to warm up for 2-3 minutes.
7. With both hands on the handles, squeeze throttle
trigger gradually, to increase the engine speed and
engage the blades.
NOTE: Allow engine to warm up 2-3 minutes before use.
Failure to do so will cause engine damage.
Single Edge Trimmer

STARTING A wARM ENGINE

1. Slide ignition switch to START position.
2. Push choke knob in to RUN (open) position.
3. If there is no fuel in the clear return line, push primer
bulb 3-4 times or until fuel is visible in the line.
4. Pull starter rope using short pulls, 1/2 to 2/3 of the
rope length.
5. If engine fails to start in 4 pulls, use cold start procedure.
6. With both hands on the handles, squeeze throttle
trigger gradually to increase the engine speed and
engage the blades.
10

STARTING A FLOOdEd ENGINE

1. Remove the cap from the spark plug and unscrew the
plug with a spark plug wrench. If the end of the spark
plug is wet, the engine may be flooded.
2. Use a paper towel or clean rag to dry the end of the
spark plug.
3. Reinstall the spark plug and cap.
4. Push the choke knob in (open position) and pull starter
rope three to four times.
5. Now pull the choke knob out (closed position) and pull
the starter rope until the engine sputters.
6. Finally, push the choke knob in (open position) and
pull the starter rope to start the engine

STOPPING THE ENGINE

1. Release the throttle trigger and allow engine to idle.
2. Slide ignition switch to the STOP position.
3. Make sure blades have come to a complete stop
before releasing either handle.

TRIMMING

If engine does not stop when switch is put in the
stop position, release the throttle trigger, allow
engine to idle.
Put the trimmer down, and pull the choke knob
out to cold stop, (closed) position.
Blades coast after releasing throttle or stopping
engine.
Keep a firm grip with both hands while blades are
moving and/or engine is running.
Do not stand on the top of a ladder while trimming.
Make sure your ladder or other support is stable
and on firm ground.
Keep a sure footing. Do not overreach.
If your trimmer becomes jammed, release throttle
and stop engine. Make sure blades have stopped
completely, then remove the obstruction.
LITTLE
WONDER
TRImmER