Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Electrical Installation:
1.
Install your refrigerator to the closest outlet. The use of
extension cord is not recommended.
Electrical Installation:
2.
Where possible, avoid connecting other electrical appliances to
the same outlet as your refrigerator while it's in use. This will
1.
Install your refrigerator to the closest outlet. The use of
prevent fluctuations in voltage and overheating of the
extension cord is not recommended.
2.
Where possible, avoid connecting other electrical appliances to
refrigerator.
the same outlet as your refrigerator while it's in use. This will
3.
To connect and disconnect your refrigerator, take the cord by the
prevent fluctuations in voltage and overheating of the
plug and remove it. Never pull on the cable.
refrigerator.
Your refrigerator comes equipped with a type "Y" polarised
4.
3.
To connect and disconnect your refrigerator, take the cord by the
power cord, which includes a grounding cable. Do not remove
plug and remove it. Never pull on the cable.
Your refrigerator comes equipped with a type "Y" polarised
4.
the ground prong by using a two-prong adaptor, or cut the cable
power cord, which includes a grounding cable. Do not remove
to replace the original plug for a two-prong plug.
the ground prong by using a two-prong adaptor, or cut the cable
If you live in a region where there are voltage and frequency
5.
to replace the original plug for a two-prong plug.
variations, don't connect your refrigerator into the outlet. You
If you live in a region where there are voltage and frequency
5.
must install an automatic voltage regulator with a minimum
variations, don't connect your refrigerator into the outlet. You
must install an automatic voltage regulator with a minimum
power of 500 Watts for 1000 Watts. Make sure the regulator can
power of 500 Watts for 1000 Watts. Make sure the regulator can
handle your region's variations in tension.
handle your region's variations in tension.
6.
If the supply cord is damaged, it must be replaced by the manufac-
6.
If the supply cord is damaged, it must be replaced by the manufac-
turer, its service agent or similarly qualified persons in order to
turer, its service agent or similarly qualified persons in order to
avoid a hazard.
avoid a hazard.
IMPORTANT
IMPORTANT
Ignoring the above-mentioned advice places the responsibility for any personal
or material risk entirely with the customer.
Ignoring the above-mentioned advice places the responsibility for any personal
or material risk entirely with the customer.
9
9
Publicité
Chapitres
Table des Matières
