Fagor Ingenious Z Série Guide D'installation Et D'utilisation page 43

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Frequently Asked Questions and Operating Guide
Problem
Ice cubes vary in size
Smart Station isn't chilling
Unusual Noises
Refrigerator is not
cooling items
External Condensation
External condensation on
exterior door (depending
on model)
Probable Cause
The water cylinder wasn´t filled up to the
maximum level.
The refrigerator is resting on a sloped floor,
and/or it itself is inclined. Thus, some ice-tray
cubes might not get fully filled. (The water
cylinder has the exact volume space for
water as the ice-tray.)
The refrigerator must have a certain incline
backwards. This may cause the ice-tray to lie
slightly unevenly.
Freezer duct or grille obstructed.
It has been installed in an unsuitable place.
The levelling is not adequate.
The accessories are not well positioned.
It has been installed in an unsuitable place.
The air circulation is obstructed.
Door is being left open for excessive amounts of time.
The knob on the exterior temperature display
has been incorrectly set.
Refrigerator is exposed to direct heat or sunlight.
Elevated humidity in the atmosphere
(higher than 75 % RH).
The access door is not being closed properly.
On high temperature and high humidity
environments your refrgerator may show
condensation on the acces door.
43
What to Do
Don't add more water as this could spill out
and/or could mean more force will be required to
release the ice cubes.
The variation in size of ice cubes is normal.
Check that there aren't any objects or foods
obstructing the air-way in the freezer´s air flow
grille (grille at the front of the compartment).
See the installation instructions.
Adjust the levelling knobs.
Adapt them in accordance with instructions.
See installation instructions.
Don't allow air outlets to be obstructed.
Only open refrigerator doors for necessary time.
See operating and user guide.
See installation instructions.
It is normal for atmospheric humidity to be higher
than 75%.
Check that there aren't any objects inside the
access door keeping it from closing.
This is a normal condition in the performance
of the unite. Sweep it with a dry cloth
whenever you feel it is needed.

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Prismatic z sérieGlass série

Table des Matières