Fagor Ingenious Z Série Guide D'installation Et D'utilisation page 20

IMPORTANT
When removing the ice cubes, pull the handle all the way down. You will feel resistance at
this point, but you need to pull a little more so that the ice-tray twists and releases the ice
into the lower compartment. Once this point has been reached, the process is complete.
Cleaning Your Smart Fill Ice Factory
When cleaning your Smart Fill Ice Factory it is imperative that you
only use a soft sponge with water and a neutral soap. Afterwards,
leave it to dry.
DO NOT use a steel wool sponge or detergent to clean the SFIF
(especially the ice-bucket), as this could affect how it works, change
how it looks, and affect the flavour of your ice cubes.
Cleaning the Cylinder
Only use a soft sponge with water and a neutral soap to clean.
Afterwards, leave it to dry. Don't use steel wool sponges or
detergents, knives or forks as these could scratch or damage the
central valve. If there's frozen water inside the cylinder, let it melt
or use tepid water to speed up the process.
Cleaning the Tray
1.- Firstly, open the front door where you see a small lip on the
right-hand side. Pull the door towards you until completely
open.
2.- Then, to remove the ice-tray from its fitting, take it by the
right-hand side and at the same time, pull it down and towards
you. Finally, pull it out by the centre, keeping it horizontal.
3.- To replace the ice-tray in the Smart Fill Ice Factory, align the
short sides with the lateral fittings and push it until it's
completely inserted.
4.- Afterwards, push the tray by the right-hand side until you hear
a click, which will ensure the tray securely in place while
working. Close the lid of the Smart Fill Ice Factory. Your device
will be ready for use once again.
IMPORTANT
Use tepid water to remove residual ice which will form with regular use of the Smart Fill
Ice Factory. This residue could form on the lid you use to fill the water cylinder, the
cylinder valve, and the ice-box, thus affecting the working of different parts of the
system.
Don't use ice-picks, forks, or knives to remove the residual ice as to do so could damage
the Smart Fill Ice Factory.
20