Profibus Dp Interface - Bartec BAT VGA pro Manuel D'installation

Operator´s manual for BAT VGA pro
Version 1.1
4.5

PROFIBUS DP interface

Connection of a controller via a PROFIBUS DP interface of the display terminal.
PROFIBUS DP module
Terminal compartment of the terminal
Data Out
Data In
See the interface description from the controller manufacturer for the relevant pin assignment of the controller.
Pins 1-3, 2-4 are already connected inside.
E_BMS00680_Rev7.doc • Operator´s manual for BAT VGA pro • Revision 7 / Status: 29. January 2004 • Technical data subject to change
A
B
A
B
PE
Controller
to other display terminals
if final device is in bus (termination)
Page 49