Notes On The Installation Of The Terminal; Safety Instructions; Maintenance; Servicing - Bartec BAT VGA pro Manuel D'installation

Operator´s manual for BAT VGA pro
Version 1.1
3.

Notes on the installation of the terminal

3.1

Safety instructions

For electrical appliances, the appropriate regulations for setting-up and operation have to be observed (e.g. directive
1999/92/EC, directive 94/9EC, ElexV, IEC/EN 60 079-14 and VDE 0100).
The operator of an electrical appliance in an area where there is an explosion hazard has to maintain the resources in a
proper condition, operate them correctly, monitor them and carry out maintenance and repair work (ElexV and
EN 60 079-14).
Where the IP rating is concerned, only original replacement parts may be used (e.g. lid seal).
Do not open the device while connected to an electrical supply !
3.2

Maintenance

For the maintenance, servicing and checking of associated resources, adhere to the valid regulations in accordance with
directive 1999/92/EC, IEC 60079-19 and EN60079-17 !
Installation / dismantling, servicing and maintenance work may only be carried out by trained specialists. The general
statutory regulations and other binding directives on workplace safety, accident prevention and environmental protection
must be adhered to.
Observe the national disposal of waste regulations when disposing of this equipment at te end of its usefull life.
3.2.1

Servicing

If operated correctly, in accordance with the installation instructions and environmental conditions, no regular servicing is
necessary.
3.2.2

Inspection

In accordance with IEC 60079-19 and EN 60079-17, the site operator has an obligation to ensure that any electrical
appliance installed within, an area containing gases and dust, which could be potentially explosive, is correctly installed
by trained personnel and that the installation is regularly inspected and correctly maintained to ensure the safety of the
operatives in the area.
3.2.3

Repair

Repairs to explosion protected resources may only be carried out by authorised persons using original replacement parts
and in accordance with up-to-date technology. The appropriate valid regulations are to be adhered to. If in doubt contact
BARTEC.
E_BMS00680_Rev7.doc • Operator´s manual for BAT VGA pro • Revision 7 / Status: 29. January 2004 • Technical data subject to change
Page 38