Installation Options; Cable Glands / Conduits - Bartec BAT VGA pro Manuel D'installation

Operator´s manual for BAT VGA pro
Version 1.1
3.3

Installation options

The terminal can be installed directly in
switch cabinet doors
mimic panels
housings
The enclosures may be made of plastic or metal. Only synthetic material with a surface resistance lower then 10
acc. EN 50014 allowed.
In order to guarantee IP 65, the housing's own IP rating has to be suitable for the application
The following points should be taken into consideration when installing the display terminal:
convenient height for operation
good lighting so that the display will be easily readable
at ambient temperatures below 0°C, the display terminal has to be heated
below +10°C the display terminal needs to be heated to maintain the lifetime of the
background lighting.
avoid installing in the immediate vicinity of switching devices or converters.
Note: Only use heating systems, which are certified for explosive areas !
The following factors should be taken into consideration in order to ensure proper and workmanlike installation:
the installation location must be sufficiently stable / fixed
the housing in which the display terminal is mounted must be strong enough to support its
weight
following the cutting out of the opening into which the display terminal is to be fitted, the
surface must be dressed to ensure it is smooth, level and undamaged so as to preserve the
integrity of the seal.
3.3.1

Cable glands / Conduits

When connecting cables and leads to supplies / communications equipment in increased safety protected areas, Ex
certified cable entries must be used which are suitable for each type of cable and lead. You must maintain the protection
concept "e" and include a suitable sealing element so that an IP rating of at least IP 54 is maintained.
E_BMS00680_Rev7.doc • Operator´s manual for BAT VGA pro • Revision 7 / Status: 29. January 2004 • Technical data subject to change
Page 39
Ω is
9