Bosch DHD Serie Manuel D'installation page 10

Remote or Inline Blower (see Figures 10
and 11 for further detail):
Y A. Remove junction box cover and con-
nect conduit with 5 wires from remote
blower. Hook up wires per Wiring.Fig. 10.
Replace junction box cover.
Y B. Attach Duct Transition Box at moun-
ting holes with sheetmetal screws.
Y C. Feed remote blower pigtail through
strain relief.
Y D. Attach strain relief to downdraft near
junction box.
Y E. Connect pigtail to downdraft at 6 pin
connector.
Y F. Run pigtail wires to junction box.
Y G. Inside junction box, connect conduit
with five wires from remote or inline blo-
wer. Use a conduit connector to secure.
Duct Transition Box
Fig. 10 – Remote Blower
10
Integral Blower VTN600CV2C (see Figures
10 and 12 for further detail):
Note: Blower and duct transition box may
be installed with duct outlet left, down or
right. Install blower or duct transition in
such a way that access panels can be
removed for service.
Y H. Place the cooktop in countertop ope-
ning with the rear edge of cooktop over-
lapping the front edge of the vent. Make
sure rear edge of cooktop does not bind
against front of snorkel.
Follow the manufacturer's installation In-
structions for installing gasket strips,
protective heat tape (if required), secu-
ring the cooktop to the countertop and
making the cooktop electrical and/or gas
connections.
Note: Check boxes as tasks are completed.
6 Pin Connector
Strain Relief
Conduit To Re-
Remote Blower
mote Blower
Pigtail
Junction Box