Emerson WELLAND CF610VS00 Manuel Du Propriétaire page 8

BP7495 CF610 Welland.qxp_ BP7495 3/10/15 4:21 PM Page 8
3.10
Position the switch housing assembly on the switch
housing adapter and align the holes in the switch
housing assembly with the holes in the adapter.
Secure the switch housing assembly by reinstalling
the three #8-32 x 5/16" flat head screws (previously
NOTE: Do not pinch wires between the switch
removed in Step 3.8) (Figure 9).
housing assembly and the switch housing adapter.
3.11
Carefully turn partially assembled fan upside down and
place in styrofoam carton, in preparation for final
installation.
Remove the hanger ball by loosening the setscrew in
the hanger ball until the ball falls freely down the
downrod (Figure 10).
Remove the pin from the downrod, then remove the
hanger ball.
Retain the pin and hanger ball for reinstallation in
NOTE: Do not loosen the screw holding the green Step 3.17.
ground wire.
3. Ceiling Fan Assembly
(Continued)
REINSTALL SWITCH HOUSING #8-32 x 5/16"
FLAT HEAD SCREW (3)
Figure 9
PIN
GREEN
GROUND
WIRE
Figure 10
8
SWITCH
HOUSING
ASSEMBLY
HANGER BALL
SETSCREW
(LOOSENED)
4.5" DOWNROD
E.T.L. Model No.: CF610