Emerson WELLAND CF610VS00 Manuel Du Propriétaire page 7

BP7495 CF610 Welland.qxp_ BP7495 3/10/15 4:21 PM Page 7
3.7
Rotate the switch housing adapter on the fan motor
assembly by engaging the keyhole slots of the switch
housing adapter with the loosened screw heads on the
fan motor assembly (Figure 6).
With the switch housing adapter locked into position,
tighten the two previously loosened screws.
Reinstall the #8-32 x 5/16" round head screw
(previously removed in Step 3.6) to secure the switch
housing adapter (Figure 6).
3.8
Remove the three #8-32 x 5/16" flat head screws
(Figure 7) from the switch housing assembly.
Retain the screws for future use in Step 3.10.
Spare #8-32 x 5/16" flat head screw is provided in parts
NOTE: If you are using an Emerson light fixture
bag if needed.
with your fan. Remove the screw plug from the
bottom of the switch housing cover and install the
light in accordance with the light kit Owner's
Manual. Make light kit electrical connections to blue
and white leads marked "For Light" in the switch
housing assembly. Follow light kit instructions for
wiring and installation. Then reinstall switch
housing as outlined above.
3.9
Engage the connector of the switch housing assembly
with the fan motor connector (Figure 8).
The two connectors are keyed and color-coded and
must be mated correctly (color-to-color) before they can
be engaged. Make sure the connector latch closes
properly.
3. Ceiling Fan Assembly
(Continued)
ROTATE SWITCH
HOUSING ADAPTER
CLOCKWISE TO
SECURE
Figure 6
SWITCH HOUSING #8-32 x 5/16"
FLAT HEAD SCREW (3)
Figure 7
Figure 8
Please contact 1-800-654-3545 for further assistance
7
REPLACE ONE
#8-32 x 5/16" ROUND
HEAD SCREW
SWITCH
HOUSING
ADAPTER
FAN MOTOR
ASSEMBLY
SWITCH
HOUSING
ASSEMBLY
SWITCH HOUSING
ASSEMBLY
SWITCH HOUSING
ASSEMBLY
CONNECTOR
FAN MOTOR
CONNECTOR
emersonfans.com
E.T.L. Model No.: CF610