3M DBI SALA 8000000 Manuel D'utilisation page 15

Manufacturer's instructions supplied with this product at time of shipment must be followed for proper use, maintenance,
2
and inspection. Alteration or misuse of this product, or failure to follow instructions may result in serious injury or death.
Inspection: Before each use inspect ripod to determine if it is in good condition and working properly. At least monthly,
tripod should be inspected by a competent person in accordance with the User Manual. Do not use if inspection reveals
an unsafe or defective condition. Not user repairable.
Use: To erect tripod, pull leg downward as shown and swing leg fully outward. Check to see that lock has engaged. To
collapse, pull leg downward and swing leg in. Adjust tripod height and level tripod head by adjusting telescopic lower
leg(s). Tripod must be generally level and on solid footing for safe use. Adjust tripod leg chains to remove excess slack.
To prevent tipping, load must remain inside chain perimeter. If required (See user manual) connect backup fall arrest
system to eye bolt located under tripod head. Make only compatible connections. See user manual for details on making
connections. Do not allow fall arrest, rescue, or personal riding systems to contact sharp edges or abrasive surfaces
during use. Use caution applying this equipment near hazardous thermal, electrical, or chemical sources. Refer to User
manual for additional information.
15