Part 2 Pb-950Kb 3X3 Large Cassette Standard Panel; Part 3 Pb-950Mb 3X3 Large Cassette Panel With Intelligent Eye - Haier FlexFit Série Mode D'emploi

CASSETTE INDOOR PANELS

Part 2 PB-950KB 3x3 Large Cassette Standard Panel

2.1 General
A. The PB-950KB panel must be ordered separately when ordering the indoor cassette unit.
2.2 Compatibility
A. The PB-950KB panel shall be compatible with FlexFit Pro Large Cassette indoor units, AL24LP2VHA,
AL36LP2VHA and AL48LP2VHA.
2.3 Installation
A. The cassette must be installed with a 1 inch recess beyond the ceiling surface to allow the panel to properly fit
flush against the ceiling and to allow the panel gasket to seal against the cassette.
2.4 Filter
A. The cassette indoor unit shall have a removable air filter.
B. The air filters shall be washable and reusable.
2.5 Air Flow Control
A. The PB-950KB shall have horizontal louvers on all sides to direct the air flow.
B. The PB-950KB shall have individual louver control.

Part 3 PB-950MB 3x3 Large Cassette Panel with Intelligent Eye

3.1 General
A. The PB-950MB panel must be ordered separately when ordering the indoor cassette unit.
3.2 Compatibility
A. The PB-950MB panel shall be compatible with FlexFit Pro Large Cassette indoor units, AL24LP2VHA,
AL36LP2VHA and AL48LP2VHA.
3.3 Installation
A. The cassette must be installed with a 1 inch recess beyond the ceiling surface to allow the panel to properly fit
flush against the ceiling and to allow the panel gasket to seal against the cassette.
3.4 Filter
A. The cassette indoor unit shall have a removable air filter.
B. The air filters shall be washable and reusable.
3.5 Air Flow Control
A. The PB-950MB shall have horizontal louvers on all sides to direct the air flow.
B. The PB-950MB shall have individual louver control.
3.6 Intelligent Eye
A. The PB-950MB shall have a heat mapping sensor.
B. The heat mapping sensor shall map 24.5ft (7.5m) in all directions.
C. The PB-950MB shall set the louvers to avoid heat signatures when set to 'Evade' when using the YR-HBS01
controller.
D. The PB-950MB shall set the louvers to follow heat signatures when set to 'Follow' when using the YR-HBS01
controller.
31-5000407 Rev. 0
21