When The Low/Status Lamp Glows; Replacement Parts - Panasonic ES‑LV9Q Mode D'emploi

Notes
• The cleaning liquid will decrease every time it is used, but do not
add detergent and water except when replacing the cleaning liquid.
Doing so may deteriorate the cleaning function.
• Do not wash the self‑cleaning recharger unit with water.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, or cracking or discoloration of
the parts.
Wipe with diluted soapy water.
• Some cleaning liquid components and skin oil may separate and
adhere to the cleaning liquid unit and cleaning liquid filter. This
does not indicate a problem.
► When the water does not drain from the cleaning tray
• Do not tilt the self‑cleaning recharger to pour out water. Doing so
may cause the cleaning liquid in the cleaning liquid unit to spill or
cause the self‑cleaning recharger to malfunction.
• Beard trimmings may clog the drain at the
bottom of the cleaning tray.
In this case, you cannot clean or dry the shaver.
1. Be sure to remove the AC adaptor from the
self‑cleaning recharger.
2. Place the self-cleaning recharger on a flat
surface, and push the beard trimmings down
through the drain (b) with a toothpick etc.

►Replacement parts

Replacement parts are available at your dealer or Service Center.
Replacement parts for
ES‑LV9Q
Special Detergent for Shaver Cleaning & Charging System WES4L03
ES-LV9Q_US.indb 19
System outer foil WES9177
Inner blades WES9170

When the LOW/STATUS lamp glows

It indicates that the cleaning liquid is due for replacement when
the LOW lamp or STATUS lamp glows for approximately
5 seconds when the SELECT button is pressed.
Lamp on the
self-cleaning recharger
The LOW lamp glows.
The STATUS lamp glows.

Content of notification
Replacement of the cleaning
liquid is required in approximately
7 days.
Prepare the detergent.
Replace the cleaning liquid.
(Modes other than the "AUTO" mode
can be used even if it is not replaced.)
If you think the replacement
should not be due yet.
• Is the cleaning liquid unit
correctly attached?
• Is the self‑cleaning recharger
placed in a level surface?
• Is the self‑cleaning recharger used
outside the range of the
recommended usage temperature?
(Only "Charge" mode can be used.)
19
2018/03/02 15:51:19