Cleaning With The Brush; Replacing The System Outer Foil And The Inner Blades - Panasonic ES‑LV9Q Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

► Drying the shaver without the self-cleaning recharger
Dry in a shade and apply oil.
Notes
• Be careful not to hit the main body on the sink or any other object
while draining the water. Failure to do so may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, or cracking or discoloration of
the parts.
Wipe with diluted soapy water.
• Do not use any kitchen or bathroom detergents other than hand
soap.
Doing so may cause malfunction.
• Do not use the self‑cleaning recharger while droplets or soap
remain on the shaver.
Doing so may change the concentration level or composition of the
cleaning liquid in the cleaning liquid unit, which may degrade
cleaning, sterilization, lubrication and drying performance. This may
also cause cleaning liquid to spill from the self‑cleaning recharger.
ES-LV9Q_US.indb
17

Cleaning with the brush

Remove the outer foil section and the inner blades.
(See page 18.)
► Cleaning with the long brush
Clean the outer foil section, system
outer foil, the shaver body and the
trimmer using the long brush.
► Cleaning with the short brush
• Clean the inner blades using the short
brush by moving it in direction as
illustrated.
• Do not move the short brush
perpendicularly against the blades as
it will damage the inner blades and
affect their sharpness.
Replacing the system outer foil and
the inner blades
appears on the lamp display once a year. (Based on one
3‑minute shave use per day)
We recommend checking the system outer foil and the inner
blades when it appears.
Press the power switch for more than 30 seconds to turn off
Even if
is not turned off right after the replacement, it will
automatically turn off within approximately 7 uses.
system outer foil
once every year
inner blades
once every two years
.
17
2018/03/02
15:51:18

Publicité

Table des Matières

Dépannage

loading

Table des Matières